An airtight connection will cause siphoning to occur. The drain hose’s connection to the standpipe must not be airtight (e.g., not secured with tape).When applying the hose guide to the drain hose, no more than 0.8 inches (20mm) of drain hose should be between the hose guide and standpipe connection.A hose guide (or elbow bracket) must be fitted to the end of the drain hose where it connects to the standpipe.The maximum height the standpipe can be is 96 inches (244cm). The top of the standpipe must be at least 39 inches (99cm) from the floor.If a hole in the wall has been drilled, that is likely where the standpipe should be located. The standpipe should be installed according to the following specifications. The waste stack (also called a drain-waste-vent system) is the pipe that runs throughout the home collecting wastewater from toilets, sinks, and appliances like the washing machine. A standpipe is tall, vertical, and has a “U” shape base (P-trap) so that expelled washer water does not return to the washer, and wastewater and sewer gas does not come in through the washer’s drain hose. A standpipe may be located next to the washer or installed in the wall. Standpipe connectionĪ standpipe can be used to connect the washer’s drain hose to the home’s waste stack. This guide refers to a standard washer, so if your washer is unique, definitely check the manufacturer’s instructions. A standpipe or sink must be higher than the washer’s overflow line, which is usually 30–36 inches (76–91cm) or 18–30 inches (45–76cm) above the P-trap. If you are deciding which option to choose for your washer’s draining, the cost of installation, space in your laundry room, and flooding prevention are your key considerations. Arguably, a standpipe is the best connection to use, as a sink connection may cause flooding if the drain hose is not secured or if water is unable to drain from the sink because of some blockage such as an item of clothing left in the sink. As long as you follow the instructions below, either the standpipe or sink will do the job without any negative consequences. While washer drainage specifications are similar for all washers, to be safe, the manufacturer’s instructions for installing the drain hose, either in your owner’s manual or on their website, should be checked. When instructions differ, it is usually by an inch or two and will relate to the following specifications: Option one is to connect the drain hose to a standpipe, and option two is to place the drain hose in a nearby sink. When connecting the drain hose, height and safety specifications must be followed to avoid flooding,having dirty water return to the washer, and having water drain from the washer when it is not supposed to. If you are deciding which washer drainage option to choose or wondering how to install the washer’s drain hose, have no fear, our guide is here to help. In most cases, you have two options for draining water from your washer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |